[Sep 14, 2025] Pass D-PSC-MN-01 Review Guide, Reliable D-PSC-MN-01 Test Engine [Q34-Q56]

NEW QUESTION 34
In PowerScale hardware maintenance, why is it essential to track the installation and maintenance of FRUs?

NEW QUESTION 35
A platform engineer is tasked with adding F600 nodes to an existing Dell EMC PowerScale cluster. After racking and stacking the F600 nodes, they determine that the cluster contains X210 and H400 nodes.
What should the platform engineer consider?

NEW QUESTION 36
What is done with the components when a Gen6 single node is replaced?

NEW QUESTION 37
What is a crucial preliminary task before performing any hardware maintenance on a PowerScale cluster?

NEW QUESTION 38
During the replacement of a failed hard drive, a key FRU, what steps should be followed to ensure proper installation?

NEW QUESTION 39
A platform engineer plans to set up a rack system for a Dell PowerScale cluster installation.
What is a requirement for the initial setup?

NEW QUESTION 40
What type of NIC is used for the external network on a Dell EMC PowerScale F600 node?

NEW QUESTION 41
A platform engineer is creating a new Dell EMC PowerScale cluster that must meet SEC 17a-4f rules. Node 1 is powered on and cabled.
What action is needed to meet the requirement?

NEW QUESTION 42
When configuring a PowerScale cluster for Hadoop integration, what are key considerations?

NEW QUESTION 43
A platform engineer is adding three F600 nodes to a Dell PowerScale cluster.
What is a good practice when adding the nodes?

NEW QUESTION 44
What type of privileges are required to perform tenant-specific administration?

NEW QUESTION 45
A Dell PowerScale platform engineer is on site to perform a node replacement. The serial number on the tag does not match the serial number provided by the customer. The platform engineer suspects the tag is incorrect.
Which command can they run to obtain the serial number of the node?

NEW QUESTION 46
A platform engineer is installing a fully populated Dell PowerScale Gen 6 chassis in a customer rack.
However, the equipment lift is broken.
What is the appropriate course of action to take before attempting to lift the chassis?

NEW QUESTION 47
What are essential steps when creating a new PowerScale cluster?

NEW QUESTION 48
What is an important consideration when connecting Dell PowerScale Gen6 nodes to external power?

NEW QUESTION 49
When setting up internal networking for a PowerScale cluster, what is a crucial requirement?

NEW QUESTION 50
A platform engineer is installing a Dell PowerScale cluster with 12 F200 nodes. They are using breakout cables.
What is the speed of the back-end port of the nodes if the switchport is 100 GbE?

NEW QUESTION 51
In the context of PowerScale, what is the purpose of the SRS tool?

NEW QUESTION 52
What is the purpose of SolVe Desktop?

NEW QUESTION 53
A platform engineer is installing a Dell EMC PowerScale cluster with 12 F200 nodes.
What is the correct ratio used for the breakout cable?

NEW QUESTION 54
A platform engineer must replace a failed chassis on a Dell PowerScale Gen6 cluster. What must the engineer do after powering off the nodes?

NEW QUESTION 55
Which action is critical when preparing the site for a PowerScale installation?

NEW QUESTION 56
A customer is planning to add a node to a Dell PowerScale cluster running OneFS 9.0.
Which command can they use from the CLI?