Category ICGB

Q16. The use of station warning lights, tool boards and jidohka devices in the application of Lean accomplish which of these principles?

Q17. Long-term Data represents all the variation that one can expect within the subject process.

Q18. Contingency Tables are used to perform which of these functions?

Q19. The purpose of a Process Map is to identify the complexity of the process and to record all actions and decision points in the process.

Q20. To create standardization of financial benefit calculations project savings are typically based on savings over what period of time?

Q21. In order to standardize project savings financial calculation such project benefits can be compared the financial savings are typically calculated over what period of time?

Q22. A Lean Principle that addresses efficiency by the process worker is called ____________________?

Q23. The reported Cpk for a process with an average of 94 units, a spread of 22 units and upper and lower specification limits of 125 and 80 units would be?

Q24. Voice of the Customer is a Lean Six Sigma technique to determine __________________ attributes of a product or service.

Q25. When creating a Cause and Effect Diagram the team needs to continually broaden their view as well as drill down until they identify all the potential ______________ impacting their process.

Q26. To create standardization of financial benefit calculations project savings are typically based on savings over what period of time?

Q27. According to the definition of Rolled Throughput Yield which of the following items best describe the purpose of RTY?

Q28. The purpose of a Process Map is to identify the complexity of the process and to assist in identifying critical steps in the process.

Q29. Significant variation in process performance is a consequence of several causes that can be classified using terminologies shown here. (Note: There are 2 correct answers).

Q30. While management of a company must set the stage for all improvement efforts, which of these 5S’s is primarily driven by management?

Q31. Inferential Statistics is largely about Significance. There are both Practical and _______________ Significance to consider during an analysis of data in a Lean Six Sigma project.

Q32. According to the definition of Rolled Throughput Yield which of these items best describe the purpose of RTY?

Q33. Lean focuses on the sequence of activities and work required to produce a product or a service. This flow is called a ___________________.

Q34. The Purchase Orders for Glenn Manufacturing Company were being copied by an employee and sent to four different departments yet only one department took an action based on the information in the PO. This is an example of ____________.