2026 NACE-CIP1-001 Question Bank Free PDF Download Recently Updated Questions [Q21-Q42]

Q21. An Inspector should change position when:

Q22. To achieve consistently accurate results with ALL alt test equipment

Q23. If a Thermoset coating is heated it will:

Q24. A magnetic pull-off type gauge is a good choice when:

Q25. A single application coating film has a measured dry film thickness (DFT) between 4 and 5 mils (between 100 and 125 microns). The volume solids of the coating immediately before application were 67%, What wet film thickness (WFT) was applied?

Q26. Galvanic corrosion occurs on which of the following substrates:

Q27. Safety Data Sheets must be carefully reviewed by:

Q28. You are an inspector on a project where SSPC SP 3 is specified.
What sort of tools should you expect the Contractor to use to achieve the standard?

Q29. If the specifier does not identify a restriction level in accordance with SSPC PA 2, the default restriction level is:

Q30. In the event of a conflict between the project specification and the coating manufactures’ product data sheet, the Inspector’s first course of action should be too:

Q31. A NACE Coating Inspector is permitted to transport coating material when:

Q32. When holiday testing is required the Inspector is always required to enforce NACE SP 0188:

Q33. Check abrasive blast pressure close to the

Q34. The main responsibilities of the inspector are to

Q35. When using the ISO comparator in accordance with ISO 8503, if the surface profile does not directly compare to one of the four segments the inspector should:

Q36. Inspection documentation is important because:

Q37. Which is a component that supplies most of the features and functions of the material?

Q38. The initial steel condition is important to the NACE Inspector because:

Q39. Passivation can best be described as:

Q40. When the joint NACE/SSPC abrasive blast cleaning standards are specified, the pictures in SSPC VIS 1 can be used as:

Q41. ISO SA 3 is directly equivalent to:

Q42. To be of value the Inspector’s documentation must be: