Practice NACE-CIP1-001 Questions With Certification guide Q&A from Training Expert [Q16-Q35]

NO.16 Prior to using Inspection Tools the inspector must:

NO.17 Inspector’s daily reports are used:
Select All That Apply

NO.18 Fine cracks in the surface of a coating that rarely reach the substrate are called

NO.19 When applying Thermal Spray Coatings the specification is most likely to refence:

NO.20 Owners hire NACE Inspectors’ with the expectation that:

NO.21 Most industrial coatings are:

NO.22 You ate the NACE Inspector on a job where NACE No. 2/SSPC – SP 10 has been specified. You are finding the Contractor is leaving mill scale on the on surface and as a result you have been rejecting the blast. The Contractor is very upset and has told you that the standard permits up to 5% of the mill scale to remain and still be in be in compliance with the standard.
Your FIRST preferred course of action is to:

NO.23 The most important factor resulting in improved job site safety is:

NO.24 Relative humidity is

NO.25 Stripe coats are generally applied to:

NO.26 The form of corrosion that has the largest potential for unexpected catastrophic failure is:

NO.27 On a blast-cleaned surface, Ian ultraviolet light is generally used to detect

NO.28 According to SSPC PA 2 a Spot Measurement is:

NO.29 Conventional spray is a good choice when:

NO.30 The Inspector should record the serial numbers of inspection instruments:

NO.31 Common errors that can produce inaccurate readings when using Wet Film Thickness (WFT) gauges include:
Select All That Apply

NO.32 In a non-convertible coating the role of the primary solvent is to:

NO.33 NACE Level 1 Inspectors have been trained to perform:

NO.34 Galvanic corrosion occurs on which of the following substrates:

NO.35 Osmotic blistering is most likely to occur as a result of