Tag NCM-MCI-5.20 exam questions vce

NEW QUESTION 66
A customer has NearSync configured. When the administrator tries to restore a snapshot from 3 minutes ago, it is not available. The snapshots are happening at 15-minute intervals instead of at the 5-minute configured interval. When the protection domain was initially set up, the snapshots were happening at the expected 5-minute interval.
What should the customer do to enable the snapshots to happen at the expected interval?

NEW QUESTION 67
An administrator has a custom backup application that requires a 2TB disk and runs in Windows. Throughput is considerably lower than expected.
The application was installed on a VM with the following configuration:
* Four vCPUs with one core/vCPU
* 4GB of Memory
* One 50GB vDisk for the Windows installation
* One 2TB vDisk for the application
What is the recommended configuration change to improve throughput?

NEW QUESTION 68
Which method can be used to migrate a VM configured for UEFI-boot from a Nutanix Hyper-V cluster to AHV?

NEW QUESTION 69
An Administrator Wants a VM to Communicate with two Separate VLANs.
What steps should the administrator complete?

NEW QUESTION 70
An administrator needs to take a single node down for maintenance. Which two steps should the administrator take? (Choose two)

NEW QUESTION 71
When Does AOS automatically Generate a case with nutanix Support?

NEW QUESTION 72
A three-node cluster has a Nutanix Files instance with three FSVMs.
What happens after a node failure?

NEW QUESTION 73
An administrator manages the following two Nutanix AOS 5.15 cluster environment:
* Corp-cluster-01
* Corp-cluster-02
The VM images must be available only on Corp-cluster-01, but cannot be checked out to cluster Corp-cluster-02. The images also cannot be checked out to any other clusters that are registered with Prism Central in the future.
Which two configuration settings must the administrator choose when creating the image placement policy that satisfies the stated requirements? (Choose two.)

NEW QUESTION 74
An administrator has Created a new VM, but When accessing the console to monitor the guest install, the administrator sees the effect shown in the exhibit.
What is the likely cause of this issue?

NEW QUESTION 75
An administrator is deploying an application using Nutanix Volumes. After configuring the volume group and connecting the guest’s iSCSI initiator to the volume group, they begin performance testing.
The administrator learns that performance on the virtual disk attached to the iSCSI initiator is far less than that of a virtual disk connected directly to the VM.
Which situation is causing this condition?

NEW QUESTION 76
How should an administrator enable the recycle bin on a nutanix cluster?

NEW QUESTION 77
An administrator is currently using both 10g uplink with LACP and balance-tcp. A single VM should not be allowed to use more than a single 10G uplink, and both uplinks should be utilized.
Which two command should be used to configure the bond? (choose two)

NEW QUESTION 78
A system administrator needs to shut down an AHV node in a Nutanix cluster without causing service disruption. The administrator checks data resiliency and verifies that the cluster can tolerate a node down.
Which three steps should the administrator perform next? (Choose three.)

NEW QUESTION 79
Which command should an administrator run from the CLI to view the uplink state of all AHV nodes in the cluster?

NEW QUESTION 80
A New Project is Being rolled out to an AHV Cluster being monitored by prism Central , The Application team indicated that the application managed by the project is very memory intensive . The administrator wants to be notified about any memory constraints should they occur.
How would an administrator most effectively achieve this task?

NEW QUESTION 81
An administrator reviews the error in the exhibit, the examines the state of the cluster, the administrator finds that the AHV host is up and Functional , but the cluster capacity is low.
What will happen to the VMs on the host with this controller VM?