카테고리 AMPP

새 질문 61
When using a destructive Paint Inspection Gauge the NACE inspector must:

새 질문 62
You are the new NACE Level 2 Inspector on a Job which had been very problematic. The previous Inspector was fired due to personality conflicts with the Contractor’s supervisor. Upon arriving onsite the Contractor’s supervisor advises you In no uncertain terms that you will be the next to go, unless you cooperate with him.
Your FIRST preferred course of action Is to:

새 질문 63
Surface preparation methods for Non-ferrous metals are:

새 질문 64
You are the NACE Level 2 Inspector with the final responsibility to prepare the final report for a very large structural steel shop project which has gone very well. It Is due next week. The work has been ongoing for two years and several NACE Level 1 Inspectors have worked under your supervision throughout the project.
You find you are missing one week of daily reports for the night shift from the very beginning of the project and despite your best efforts they are cannot be found.
You FIRST preferred course of action Is to:

새 질문 65
You ate the NACE Level 2 Coating Inspector where SSPC PA 2 has been specified with an additional requirement that no Individual gauge reading shall be below a certain value. As this is not part of the standard you should:

새 질문 66
When performing a hardness test on a coating which has elastic properties the inspector is likely to observe:

새 질문 67
When observing design defects the NACE Inspector should:

새 질문 68
When observing fabrication defects the NACE Inspector should:

새 질문 69
Linings are used on the interior of pipelines to

새 질문 70
The coating applicator has ignored a surface preparation hold point and applied coating over the surface without a sign off from you as the inspector.
Your FIRST preferred course of action is to:

새 질문 71
You can use magnifiers to examine all of the following EXCEPT

새 질문 72
When completing the Final Inspection report the Inspector should write the report using:

새 질문 73
The primary purpose of Fireproofing coatings are to provide:

새 질문 74
A failure caused by applying a coating too thinly is known as

새 질문 75
Coating application to concrete substrates is: