[Q35-Q57] Download Online VALID 300-710 Exam Dumps File Instantly [Jun 11, 2022]

QUESTION 35
Drag and drop the steps to restore an automatic device registration failure on the standby Cisco FMC from the left into the correct order on the right. Not all options are used.

QUESTION 36
An administrator is setting up Cisco Firepower to send data to the Cisco Stealthwatch appliances. The NetFlow_Set_Parameters object is already created, but NetFlow is not being sent to the flow collector. What must be done to prevent this from occurring?

QUESTION 37
A network administrator notices that remote access VPN users are not reachable from inside the network. It is determined that routing is configured correctly, however return traffic is entering the firewall but not leaving it What is the reason for this issue?

QUESTION 38
A network security engineer must export packet captures from the Cisco FMC web browser while troubleshooting an issue. When navigating to the address Error! Hyperlink reference not valid. IP>/capture/CAPI/pcap/test.pcap. an error 403: Forbidden is given instead of the PCAP file. Which action must the engineer take to resolve this issue?

QUESTION 39
administrator is configuring SNORT inspection policies and is seeing failed deployment messages in Cisco FMC . What information should the administrator generate for Cisco TAC to help troubleshoot?

QUESTION 40
Which protocol establishes network redundancy in a switched Firepower device deployment?

QUESTION 41
What is a result of enabling Cisco FTD clustering?

QUESTION 42
Within Cisco Firepower Management Center, where does a user add or modify widgets?

QUESTION 43
With Cisco Firepower Threat Defense software, which interface mode must be configured to passively receive traffic that passes through the appliance?

QUESTION 44
An organization does not want to use the default Cisco Firepower block page when blocking HTTP traffic. The organization wants to include information about its policies and procedures to help educate the users whenever a block occurs. Which two steps must be taken to meet these requirements? (Choose two.)

QUESTION 45
On the advanced tab under inline set properties, which allows interfaces to emulate a passive interface?

QUESTION 46
Which two dynamic routing protocols are supported in Firepower Threat Defense without using FlexConfig?
(Choose two.)

QUESTION 47
An organization is migrating their Cisco ASA devices running in multicontext mode to Cisco FTD devices. Which action must be taken to ensure that each context on the Cisco ASA is logically separated in the Cisco FTD devices?

QUESTION 48
A network administrator is implementing an active/passive high availability Cisco FTD pair.
When adding the high availability pair, the administrator cannot select the secondary peer.
What is the cause?

QUESTION 49
Which protocol establishes network redundancy in a switched Firepower device deployment?

QUESTION 50
An engineer is building a new access control policy using Cisco FMC. The policy must inspect a unique IPS policy as well as log rule matching. Which action must be taken to meet these requirements?

QUESTION 51
Which two routing options are valid with Cisco Firepower Threat Defense? (Choose two.)

QUESTION 52
What is the result of specifying of QoS rule that has a rate limit that is greater than the maximum throughput of an interface?

QUESTION 53
Which Firepower feature allows users to configure bridges in routed mode and enables devices to perform Layer 2 switching between interfaces?

QUESTION 54
Which command-line mode is supported from the Cisco Firepower Management Center CLI?

QUESTION 55
Within an organization’s high availability environment where both firewalls are passing traffic, traffic must be segmented based on which department it is destined for. Each department is situated on a different LAN. What must be configured to meet these requirements?

QUESTION 56
An engineer must configure high availability for the Cisco Firepower devices. The current network topology does not allow for two devices to pass traffic concurrently. How must the devices be implemented in this environment?

QUESTION 57
A network administrator cannot select the link to be used for failover when configuring an active/passive HA Cisco FTD pair.
Which configuration must be changed before setting up the high availability pair?